What to do if my WAGNER SPRINT XE Paint Sprayer has no powder feed?
If the WAGNER Paint Sprayer isn't feeding powder, first check if the tank or powder tank is empty and refill it. Then, ensure the spray gun, powder feed hose, and powder suction system aren't clogged by blowing through them. Also, check if the feed air hose or powder feed hose is bent or kinked; straighten or replace them if necessary.
How to fix sputtering powder feed on a WAGNER SPRINT XE?
If you're experiencing sputtering powder feed with your WAGNER Paint Sprayer, it could be due to a low flow rate in the powder feed hose. Try increasing the total feed and dosing air, then readjust the ratio of the airs to each other. Also, make sure the powder feed hose isn't narrowed due to movement; consider using a hose with a thicker wall to prevent this. Fluctuations in compressed air can also cause sputtering; install compressed air storage directly in front of high consumption system components.
What causes bad wrap around with WAGNER SPRINT XE?
If you're experiencing bad wrap around or back-spray with your WAGNER Paint Sprayer, it could be due to insufficient grounding. Ensure that all components are well grounded.
Why doesn't the power indicator light up on my WAGNER SPRINT XE?
If the power indicator on your WAGNER Paint Sprayer doesn't light up, start by ensuring the mains are turned on. Next, check the 2 AT fuses and replace them if they are defective. If these steps don't resolve the issue, there may be a problem with the connection cable to the powder spray gun or grounding. In this case, it is recommended to contact the WAGNER service department or qualified personnel for assistance.
What to do if the feed unit doesn't sink into the powder in my WAGNER Paint Sprayer?
If the feed unit of your WAGNER Paint Sprayer isn't sinking into the powder, it might be because the guide of the feed unit holder is jammed. Ensure the guide can move smoothly.
Why is there dust buildup on my WAGNER SPRINT XE?
If you notice dust buildup above the drum or powder tank of your WAGNER Paint Sprayer, it's likely due to too much fluid air. Reduce the fluid air at the throttle to resolve this. Also, check that the throttle is correctly connected to the fluid air connection of the control unit; if not, connect it and readjust the fluid air volume.
General| Flow Rate | Adjustable, up to 600 g/min |
|---|---|
| Weight | 16.5 kg |
| Hose Length | 15 m |
| Nozzle Size | Various, depending on application |
| Spray Pattern | Adjustable |
| Voltage | 230 V |
| Power Source | Electric |
To Next Page
