WAGNER W 690 Flexio - Spray Setting Selection (Wall Extra I-Spray); Material Volume Adjustment; Gravity Spray Attachment; Wall Extra I-Spray Attachment

9
W 690 Flexio Extra Spray Kit
AUS
10. Selecting the Spray Setting
(Wall Extra I-Spray spray attachment)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
2 dierent spray jet shapes can be set by turning the air cap (g. 10, 1)
Tighten the union nut (Fig. 8, 2) fully so that no paint is able to penetrate
the device. Check regularly whether the union nut has worked loose during
operation.
Fig. 11 A = vertical at jet

for horizontal surfaces
Fig. 11 B = horizontal at jet

for vertical surfaces
Use the red adjustment lever to also switch between a wide
( ) and a narrow ( ) spray jet.
11. Adjusting the Material Volume
(Gravity spray attachment) (Fig. 12)
Set the material volume by turning the regulator on the trigger guard of the spray gun.
- turn to the left  lower material volume
+ turn to the right  higher material volume
12. Adjusting the Material Volume
(Wall Extra I-Spray spray attachment)
The volume of material can be set by turning the material volume control (Fig. 13, 1) in
steps from 1 (minimum) to 12 (maximum).