WAGNER W 690 Flexio - Air Volume Setting and Spray Technique; Air Volume Setting; Spray Technique Guidelines; Shutdown and Cleaning

10
W 690 Flexio Extra Spray Kit
AUS
13. Setting the Amount of Air (Fig. 14)
Depending on the viscosity of the material to be sprayed and the nish of the object to
be coated, it may be advisable to vary the amount of air. Very low viscosity materials, such
as watery glazes do not have to be atomised with the maximum amount of air.
This also applies for the use of the Detail and Corner&Reach spray attachment (accessory).
- turn to the right  lower amount of air
+ turn to the left  higher amount of air
14. Spray Technique
i
The spray result depends heavily on the smoothness and cleanliness of the
surface to be sprayed. Therefore the surface should be carefully prepared and
kept free of dust.
•
Cover all surfaces not to be sprayed.
i
Important: Start at the edge of the area to be sprayed. Start the spray
movement rst of all, and then press the trigger. Avoid interruptions
within the area to be sprayed.
•
The spray movement should come from the arm, not just from the wrist. This ensures that
a uniform distance is maintained between the spray gun and the spray surface during
the spray operation. Select a distance of 5 - 15 cm, depending on the desired spray jet
width. When you are using interior wall paint, the distance should be about 20-30 cm
(approx. one stirring rod in length).
Fig. 15 A/ 15 B: CORRECT Even distance to the object.
Fig. 15 B: INCORRECT An uneven distance will result in uneven paint
application.
i
"Cross spray" when using paint with a poor covering capacity or if the
surface is highly absorbent (Fig. 16).
i
Interior wall paint in strong colour shades should be applied at least twice
(allow rst paint coat to dry rst). This will ensure good coverage.
15. Taking Out of Operation and Cleaning
Proper cleaning is the prerequisite for problem-free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning. When
processing 2-component varnishes, clean the device immediately.
1) Turn the machine o. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briey turning open and then closing the