EasyManuals Logo

Waldorf Pulse User Manual

Waldorf Pulse
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
FCC Information (U.S.A.)
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions
contained in this Manual, meets FCC requirements. Modifications not expressly approved by Waldorf may void your
authority, granted by the FCC, to use this product.
2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded
cables. Cable/s supplied with this product MUST be used. Follow all installation instructions. Failure to follow
instructions could void your FCC authorisation to use this product in the USA.
3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part
15 for Class „B“ digital devices. Compliance with these requirements provides a reasonable level of assurance that
your use of this product in residential environment will not result in harful interference with other electronic devices.
This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in
the users manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC
regulations does not guarantee that interference will not occur in all installations. If this product is found to be the
source of interference, which can be determinated by turning the unit „OFF“ and „ON“, please try to eliminate the
problem by using one of the following measures:
Relocate either this product or the device that is being affected by the interference.
Utilise power outlets that are on branch (Circuit breaker or fuse) circuits or install AC line filter/s.
In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead,
change the lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results, please contact the local retailer authorised to
distributed this type of product.
CANADA
The digital section of this apparatus does not exceed the „Class B“ limits for radio noise emissions from digital
apparatus set out in the radio interference regulation of the Canadian Department of Communications.
Le present appareil numerique n’emet pas de briut radioelectriques depassant les limites apllicables aux appareils
numeriques de la „Classe B“ prescrites dans la reglement sur le brouillage radioelectrique edicte par le Ministre Des
Communications du Canada.
Other Standards (Rest of World)
This product complies with the radio frequency interference requirements of the Council Directive 89/336/EC.
Cet appareil est conforme aux prescriptions de la directive communautaire 89/336/EC.
Dette apparat overholder det gaeldenda EF-direktiv vedrørendareadiostøj.
Diese Geräte entsprechen der EG-Richtlinie 89/336/EC.
The statements above apply ONLY to products distributed in the USA.
This only applies to products distributed in the USA.
Ceci ne s’applique qu’aux produits distribués dans Canada.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Waldorf Pulse and is the answer not in the manual?

Waldorf Pulse Specifications

General IconGeneral
TypeAnalog Synthesizer
PolyphonyMonophonic
LFO1
MIDIIn, Out, Thru
KeyboardNo Keyboard
Year Released1995
Filter24dB/octave Low-pass Filter
Envelopes2 (ADSR)
WaveformsSawtooth, Triangle, Pulse
InputsCV, Gate
OutputsAudio Output
Oscillators3 Analog Oscillators

Related product manuals