Walker MBK23 - Deck Chart

Specications
6
MODEL MBK23
With DSD56 857 (389)
With DML36 771 (350)
With DML42A 798 (362)
With DML42B 803 (364)
With DML48 800 (363)
SIDE DISCHARGE DECKS
MODEL DSD36 DSD42 DSD42BD DSD48 DSD52 DSD56
Cutting Width in. (cm) 36 (91) 42 (107) 48 (122) 52 (132) 56 (142)
Drive Type Gear Belt Gear Belt Gear
Cutting Height in. (cm) 1 (3) to 4 (10) at 1/2 (1) Increments, 7 Positions
Blade Length in. (cm) 20 (51) 22 (56) 21-3/4 (55) 25 (64) 18-1/2 (47) 20 (51)
Number of Blades 2 3
Deck Suspension Torsion-Flex Frame with Counterweight Springs
Max Blade RPM
2900 2900 2900 2900 3790 3480
Max Blade Tip Speed
ft/min (m/min)
15180
(4630)
16700
(5090)
16510
(5030)
18980
(5790)
18340
(5590)
18220
(5550)
MULCHING DECKS
MODEL DML36 DML42A DML42B DML48
Cutting Width in. (cm) 36 (91) 42 (107) 48 (122)
Drive Type Gear
Cutting Height in. (cm) 1 (3) to 4 (10) in 1/2 (1) Increments, 7 Positions
Blade Length in. (cm) 19 (48) 22 (56) 21/22 (53/56) 25 (64)
Number of Blades 2 4* 2
Deck Suspension Torsion-Flex Frame with Counterweight Springs
Maximum Blade RPM 3480 2900 2900 2900
Max Blade Tip Speed
ft/min (m/min)
17310 (5280) 16700 (5090) 16700 (5090) 18980 (5790)
* DML42B is a two spindle deck equipped with two pairs of 90 degree stacked blades
NOTE: The manufacturer reserves the right to make changes in specications shown herein at any time
without notice or obligation. The specications listed are for a standard conguration tractor, and may
change with the addition of optional equipment.