Safety Instructions
16
SAFETY, CONTROL, AND INSTRUCTION DECALS
Safety, Control, and Instruction Decals are installed on the machine;
if any are missing, illegible, or damaged, a replacement should be ordered and installed before
putting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.
1. Throttle
2. Warning – read Operator’s Manual before oper-
ating the machine.
3. Warning – wear eye and ear protection when op-
erating the machine.
4. Warning – roll-over hazard
• Do not operate on slopes greater than 15
degrees.
5. Warning – thrown object hazard
• Keep bystanders away from the machine
when operating.
6. Warning – entanglement hazard
• Keep all guards in place while engine is run-
ning.
7. Parking brake
• Move lever forward to engage Parking
Brake; back to disengage.
1. Warning – do not operate the machine without a
deck or other implement attached.
2. Forward Speed Control
• Move lever forward to increase speed; back
to stop.
3. Warning – read Operator’s Manual before servic-
ing or performing maintenance.
• Engage parking brake.
• Remove ignition key.
4. Warning – do not engage PTO clutch with PTO
shaft disconnected.
5. PTO Clutch Lever
• Move lever forward to engage PTO clutch;
back to disengage.
Location: LH Fender
Part Number: 8600-25
Location: RH Fender
Part Number: 8600-26
<15°
2.
3.
4.
5.
6.
7.
1.
2.
3.
1.
4.
5.
1. 2.
To Next Page
