Walker S14i - Maintenance Instructions; Transaxle Oil and Filter Change

Maintenance Instructions LUBRICATION
52
Ident Lubrication No.
No. Location Type Places
Ident Lubrication No.
No. Location Type Places
1 Deck Caster Wheel Fork Pivot Grease 2
2 Blade Spindle Grease
Δ
2
3 Pivot Assembly, Tilt-Up Deck Grease 4
4 Deck Support Arm Socket Grease 2
5 Universal Joint Shaft Assembly Grease** 1
6 Tee Gearbox, Deck Oil* 1
7 Blade Drive Gearbox Oil* 2
8 FSC Lever Pivot Grease 1
9 Steering Lever Pivot Grease 2
10 Deck-to-PTO Coupling Grease 1
(Grease Spline Slide Area)
11 Universal Joint Tube Assembly Grease** 1
12 Deck Support Arm Pivot Grease 2
13 Hydro Idler Pivot Grease 1
14 PTO Clutch Lever Pivot Grease 1
15 Body Latch Pivot Oil 1
16 Transaxle Oil Reservoir Oil/20W-50 1
17 Clutch Actuator Push Rod Grease 1
18 PTO Belt Tightener Pivot Grease 1
19 Brake Band Pivot Pins (Clevis) Oil 2
20 Catcher Hinge Point Oil 2
21 Throttle Control Cable Ends Oil 2
22 Engine Dipstick / Oil Fill Oil*** 1
23 Engine Idler Pivot Grease 1
24 Parking Brake Clevis Oil 2
25 Parking Brake Lever Grease 1
26 Throttle Control Pivot Oil 1
* Gearboxes are permanently lubricated and sealed re-
quiring no scheduled lubrication. Oil level should be
checked only when an oil leak is noted. Refer to Mower
Deck Gearbox Lubrication in this section.
** Grease every twenty-ve (25) hours. Refer to PTO U-
Joint Lubrication (Tractor) in this section for Lubricat-
ing U-Joint on tractor.
*** Refer to Engine Oil located on page 50.
Δ
Belt Driven Decks Only
NOTE: DS42 Belt Drive and DC36R Tilt-Up Decks are shown for
reference. For other Deck Lubrication Points, Refer to
Deck and Carrier Frame Illustrated Parts Manual.
Lubrication Points for Optional Belt Driven Decks (DS42 Belt Drive Shown)
2
1
1
2
3 4
4
5 3