11
(888) 253-0777
When the dog is in the Leg Rings, the wheelchair knuckle should be at
mid-hip level. The Leg Rings should look like two Cs, not two Vs, with
the center connector holding them together.
The Leg Rings support the dog’s hindquar-
ters. They will take the weight off the legs
while still allowing the dog to use its legs
to maintain muscle mass. The Leg Rings
should hang no lower than 3" below the
frame. This will create a supportive cradle.
Here is a link for how to adjust the strapping:
https://youtu.be/3CoSfPIMWC0
Legs go
inside
each ring
Rear Support Leg Rings
Shoulder
Socket screw
The Leg Ring straps go over the frame, and the black plastic harness clips
have a slot that fits over the Shoulder Socket screws. Put your thumb into
the round circle and push upward to lock (you will hear it click into place).
The round circle will face the ground. The dog’s legs go through each
ring. To release, put your thumb in the circle and pull downward. Now,
you can slowly lower your dog to the ground.
Here is the video link of how to adjust the straps:
https://www.youtube.com/watch?v=3CoSfPIMWC0
Clip the Leg Rings to the Wheelchair
Legs go inside each ring
Leg rings should hang
about 3 inches below
the frame
To Next Page
Loading...