COMMANDER - installation guide en 17
TROUBLESHOOTING
MAINTENANCE
Your network supply is continuously checked to ensure a safety operation. If one of the parameters is not in range the charger will stop the power
supply to the vehicle.
Charging process uses a secure communication protocol (called Control Pilot) between your Wallbox and the vehicle. If the car detects a problem
during the charging process, it will be interrupted. At this point a message will pop up in your status menu.
The internal stats of the Wallbox Commander are also being parameterized in real time. A change in the normal operating values will lead the
charger to safely disconnect the power supply to the vehicle.
Please take some precautions to ensure a correct maintenance:
There are no parts inside your Wallbox Commander that need to be maintained by the user. Only qualified electrician can open and manipulate
your Wallbox Commander.
Remember that before start cleaning ensure that the power supply is turned o.
In case you want to clean up your Wallbox Commander, we recommend you to use a soft, or a dry damp cloth. Do not use a spray or
direct water to clean your Wallbox Commander.
It is mandatory to use the side socket of your Wallbox Commander to preserve your connector from falling and climate agents.
To Next Page
Loading...
