Wallenstein WX410 - Wx410

25
7. Lower the loader to move the splitter
closer to the ground.
8. Starting:
a. WX410 Model:
• Climb into cab and start engine
(refer to skid steer manual.).
• Engage the remote outlet hydrau-
lic circuit.
• Increase engine speed to mid or
3/4 RPM.
• Use the controls in cab to move
the cylinder ram and splitting
wedge.
b. WX440, WX460 and WX470 Models:
• Climb into cab and start engine
(refer to skid steer manual.).
• Engage the remote outlet hydrau-
lic circuit and place in detent.
• Set the skid steer controls to allow
for remote operation (refer to skid
steer manual for details.).
• Use the lever on the hydraulic
valve to move the cylinder ram
and wedge.
• Release the lever when the wood
or log splits into 2 pieces or the
wedge reaches the base and the
wedge will stop.
9. Emergency Stopping:
In case of an emergency, lower the frame
to the ground and stop engine (for the
WX410). For the WX440, WX460 and
WX470, climb into cab and stop engine.
Be sure to resolve and correct the emer-
gency situation before resuming work.
Do not take chances in an emergency.
Fig. 14 STARTING/STOPPING
WX410
WX470 Horizontal
WX470 Vertical