Need help?Do you have a question about the Wampler TERRAFORM and is the answer not in the manual?
General| Presets | 8 |
|---|---|
| Bypass | True Bypass |
| Power | 9V DC |
| MIDI | In/Out |
| Input Impedance | 1M Ohm |
| Power Requirements | 9V DC, Center Negative |
| Effects | Chorus, Flanger, Phaser, Rotary, Tremolo |
| Inputs | 1 x 1/4" |
| Outputs | 1 x 1/4" |
| Controls | Preset |
| Output Impedance | 100 Ohm |
How to connect and use the TERRAFORM in stereo or wet/dry/wet configurations.
How to connect and use the TERRAFORM in mono configuration with one amp.
How to place effects before or after gain stages in mono signal chains.
Global assignment of effects to be either PRE or POST in the signal chain.
Steps to save custom sound configurations to the pedal's memory slots.
Associate MIDI program changes to preset locations.
Associate MIDI program changes with the bypass function.
Configure pedal to respond to specific MIDI channels or omni mode.
Procedure to reset the pedal to its original factory settings.
To Next Page
