Wampler TERRAFORM User Manual

WAMPLER TERRAFORM Page
10
There are three ways to recall a preset.
1. Press the PRESET switch to scroll through the 8 presets.
2. Hold down the TAP TEMPO stomp until the LED changes to
green. You can then use the TAP TEMPO stomp to scroll
through the 8 presets. To return to normal TAP TEMPO
mode, hold down the TAP TEMPO stomp until the LED
changes back to blue.
3. Recall the preset via a MIDI preset change via a MIDI
controller.
MIDI
Many players are already some way down the road when it comes
to using MIDI within their rigs, but also there are a lot that see the
word MIDI and run to the hills. The MIDI applications within the
TERRAFORM are really easy, you can recall a patch from the fully
midi-mappable memory bank of the TERRAFORM and control the
tap tempo speed.
MIDI MAPPING
You can associate ANY incoming preset change of midi between 1-
128 to any of the 8 preset locations. So, if you have 4 songs that
you want a nice chorus, you don’t have to create 4 different
patches (like some other bigger box modulation units we can think
of) you can just point the TERRAFORM to call up that one patch
from those separate incoming midi patch change commands.
As listed above, during the SAVING A PRESET process, step 5 gives
the TERRAFORM the midi information it requires to recall a patch.
Just send the program change information from the midi controller
during this step and the TERRAFORM will remember it.

Wampler TERRAFORM Specifications

General

Presets	8
Bypass	True Bypass
Power	9V DC
MIDI	In/Out
Input Impedance	1M Ohm
Power Requirements	9V DC, Center Negative
Effects	Chorus, Flanger, Phaser, Rotary, Tremolo
Inputs	1 x 1/4"
Outputs	1 x 1/4"
Controls	Preset
Output Impedance	100 Ohm