Wampler TERRAFORM User Manual

WAMPLER TERRAFORM Page
19
POWER REQUIREMENT
This pedal was designed around the usage of a 9vDC power source.
To avoid damage to the pedal, do NOT exceed 18vDC, do NOT use
a center pin positive adapter and do not use AC power. Using an
incorrect power adapter can lead to damage and will void the
warranty on the pedal. This pedal draws approximately 107mA at
9v, and 108mA at 18v.
WARRANTY INFORMATION
WAMPLER PEDALS LIMITED WARRANTY.
Wampler offers a five (5) year warranty to the original purchaser
that this WAMPLER product will be free from defects in material
and workmanship. This warranty does not cover service or parts to
repair damage caused by accident, neglect, normal cosmetic wear,
disaster, misuse, abuse, negligence, inadequate packing or shipping
procedures and service, repair or modifications to the product,
which have not been authorized by WAMPLER. If this product is
defective in materials or workmanship as warranted above, your
sole remedy shall be repair or replacement as provided below.
RETURN PROCEEDURES.
In the unlikely event that a defect should occur, follow the
procedure outlined below. Defective products must be shipped,
together with a dated sales receipt, freight pre-paid and insured
directly to WAMPLER SERVICE DEPT – 3383 Gage Ave., Huntington
Park, CA 90255. A Return Authorization Number must be obtained
from our Customer Service Department prior to shipping the
product. Products must be shipped in their original packaging or its
equivalent; in any case, the risk of loss or damage in transit is to be
borne by the purchaser. The Return Authorization Number must
appear in large print directly below the shipping address. Always
include a brief description of the defect, along with your correct
return address and telephone number.
When emailing to inquire about a returned product, always refer to
the Return Authorization Number. If WAMPLER determines that
the unit was defective in materials or workmanship at time during

Wampler TERRAFORM Specifications

General

Presets	8
Bypass	True Bypass
Power	9V DC
MIDI	In/Out
Input Impedance	1M Ohm
Power Requirements	9V DC, Center Negative
Effects	Chorus, Flanger, Phaser, Rotary, Tremolo
Inputs	1 x 1/4"
Outputs	1 x 1/4"
Controls	Preset
Output Impedance	100 Ohm