WAMPLER TERRAFORM Page
ROUTING
The TERRAFORM gives you two options, full true stereo or mono
(NORMAL mode), and within that NORMAL mode you can separate
the TERRAFORM to place certain effects in different places within
your signal chain by going PRE/POST.
STEREO
Place the NORMAL/PRE POST switch to NORMAL
If you are lucky enough to be running a full stereo rig, or even a
wet/dry/wet rig, the TERRAFORM will make your tone ENORMOUS.
We’ve examined every effect individually to make sure they exist
and perform in the best possible way in stereo. You will experience
the kind of washy tones that will surround you, engulf you and
make you feel like you are swimming in a glorious spring water pool
of delicious modulated wetness. And yes, I did just say that,
because… well, it’s true. Open your sound, open your amps up, and
get those swimming shorts on. It’s time to go for a dip.
MONO
Place the NORMAL/PRE POST switch to NORMAL
If you don’t have two amps, you can still enjoy the depth of the
TERRAFORM. Simply plug your input signal into the PRE/L jack, and
use either output jack to your amp.
PRE/POST
Place the NORMAL/PRE POST switch to PRE/POST
To make the most of assigning individual effects into specific places
in your mono signal chain, it’s time to explore the PRE/POST
options. For example, a lot of players like their U VIBE before their
gain stages (whether that be an amps preamp stage, or their
favorite dirt pedal) and the CHORUS after (again, either in the
effects loop of the amp or after their dirt pedals. You can program
the TERRAFORM (in PRE/POST mode) to place each effect either
PRE or POST.
The TERRAFORM ships with some effects pre and some post, here
is how they are when you first fire it up.
PRE – U Vibe, Phaser, Flanger, Envelope Filter, Auto Wah
POST - Dimension, Chorus, Tremolo, Harmonic Tremolo, Slow Gear,
Rotary
STEREO / MONO
TERRAFORM will understand if you are running in mono - Make
sure routing switch is set to NORMAL.
To Next Page
Loading...
Need help?
General
