Wasp CLAY - Technical Data

18
2
© WASP S.r.l.
2.3. Technical data
All WASP machines and 3D printers are characterized by considerable robustness and working precision.
Their mechanics allows for greater precision and stability, guaranteeing greater production speeds.
A further advantage is the possibility of restarting the production of the piece from the point where it may have
been interrupted for some reason.
General features
Length 32 cm
Width 36 cm
Height 90 cm (158 cm with basement)
Approximated weight 60 kg (30kg maximum weight of a single component)
Noisiness < 70 db (A)
Mechanical features
Frame and cover Metal sheet and stainless steel
Movement Rotation on thrust bearing and Igus bearings
Motors ISV57 brushless
Electrical features
Input 220/240 V - 50/60 Hz (110 V on request)
Absorbed power 450W
Use features
Environment of use 15-30 °C
Warehouse 0-30 °C
Continuous feeding informations
Technology LDM
Max output 30 kg/h (measured with earthenware and 8mm nozzle)
Compatible nozzles 4, 6, 8 mm
Interface Built-in dual PWM controller/synchronous cable control*
Tank capacity 11 l
Suitable materials Earthenware, Stoneware, Porcelain, mixtures
*only supported with compatible Delta WASP 40100 Clay models. Contact support@3dwasp.com for more info