22
Transport and handling
4
© WASP S.r.l.
3.3. Content
The machine is supplied with:
• Signal cable
• Power cable
• Stainless steel braided hose 3/4” BSPT thread (female-female)
• Hose purging tool 3/4”-1/4” BSPT thread (male-male) (requires pressure water)
• WASP LDM XL 3.0 Extruder
• Spare nozzles
3.4. Lifting and handling of the machine
ATTENTION:
The weight of the machine is shown in paragraph 2.3 “Technical data”. It is therefore necessary to use
the lifting equipment whose expected flow is adequate for the weight to be lifted.
ATTENTION:
As long as the machine is not completely raised, it is advisable to check the correct balance of the
same. During lifting, all the area around the machine is considered dangerous.
ATTENTION:
All small components that exceeds the weight of 25 kg must be transported with the appropriate
equipment, or manually (if not exceeding 50Kg) by two qualified operators.
To Next Page
Loading...