To Next PageTo Next PageWhat to do if my Water Ace R1030 Water Pump won't start?
If your Water Ace Water Pump won't start or run, a possible cause is a blown fuse. The suggested solution is to replace the blown fuse with a fuse of the proper size. Another potential cause is low line voltage. If the voltage is under the recommended minimum, check the wiring size from the main switch. If the wiring is okay, contact your power company or hydro authority.
Why is my Water Ace R1030 delivering little or no water?
If your Water Ace Water Pump operates but delivers little or no water, it could be due to a restricted discharge caused by an obstacle in the piping. The suggested solution is to remove the obstacle from the piping.
Details and technical specifications of the Water Ace Sink Pump System Model R1030.
Instructions for checking received equipment and inspecting for shipping damage.
Essential safety precautions for operating and maintaining the pump.
Step-by-step instructions for assembling the sink pump system components.
Guidance on locating and connecting the pump system components correctly.
Data on pump output at various head heights and flow rates.
Procedures for routine maintenance and cleaning of the pump.
Common pump issues and their corrective actions.
List of available replacement parts with key numbers and descriptions.
Terms and conditions of the product's limited warranty.
General| Maximum Flow Rate | 30 GPM |
|---|---|
| Voltage | 115/230V |
| Outlet Size | 1 in NPT |
| Model | R1030 |
| Max Flow Rate | 30 GPM |
| Thermal Protection | Yes |
| Inlet Size | 1.25 in |
