What to do if Waters Security Sensors communications with the Dsp failed?
If communications with the Dsp failed on your Waters Security Sensors, and the Dsp firmware is not running, cycle power to the detector. If the problem persists, contact Waters Technical Service.
What to do if Waters Security Sensors Ethernet cable disconnected?
If the Ethernet cable is disconnected from Waters Security Sensors, connect (or reconnect) the Ethernet cable and reset communications from the control panel or console.
What to do if Waters Security Sensors lamp lighting failure?
If the Waters Security Sensors experiences a lamp lighting failure, cycle power to the detector. Check the lamp power connection. If the issue persists, replace the lamp.
What to do if Waters Security Sensors lamp failure?
If the Waters Security Sensors indicates a lamp failure, check the lamp icon, cycle power to the detector, and then replace the lamp.
How to fix Waters Security Sensors communication error?
If you are experiencing a communication error with Waters Security Sensors, which may result in data point loss, cycle power to both the detector and the data system PC. If the problem continues, contact Waters Technical Service.
What to do if Waters Security Sensors wavelength verification failure?
If the Waters Security Sensors experiences a wavelength verification failure, establish flow and reset the instrument. If this fails, perform erbium calculation.
How to fix Waters Security Sensors energy level too low?
If the Waters Security Sensors energy level is too low, clear the flow cell and establish flow. If the problem persists, replace the lamp. If the issue continues, contact Waters Technical Service.
What to do if Waters Security Sensors wavelength outside of allowed range?
If the Waters Security Sensors wavelength is outside of the allowed range, modify the instrument method, ensuring the wavelength end is lower than 500 nm.
What to do if Waters Security Sensors Delta between previous and current timestamp is incorrect?
If the delta between the previous and current timestamp is incorrect on the Waters Security Sensors, cycle power to the detector. If the error persists, contact Waters Technical Service to replace the personality card.
What to do if Waters Security Sensors thermal controller disabled?
If the thermal controller is disabled on your Waters Security Sensors, cycle power to the detector. If the problem persists, contact Waters Technical Service.
General| Technology | Ultra Performance Liquid Chromatography (UPLC) |
|---|---|
| Flow Rate Range | 0.001 to 2.000 mL/min |
| Maximum Pressure | 15, 000 psi (1, 034 bar) |
| Temperature Range | 4 °C to 65 °C |
| Data Sampling Rate | up to 80 Hz |
| Detector Options | Photodiode Array (PDA), UV/Vis, Fluorescence, Evaporative Light Scattering |
| Detection Wavelength Range | 190 to 800 nm |
| Column Compatibility | UPLC Columns (1.7 μm particle size) |
To Next Page
