Watersnake ASP T18-SW - CONNECTING MOTOR TO BATTERY

10
Watersnake Asp Transom Motor User Manual (Ver.3)
All Watersnake wiring connections should conform to best marine standards.
Soldered, sealed and heat-shrink protected. If you doubt your ability to
produce quality waterproof connections or lack the equipment, consult a
marine technician or auto electrician.
• Your Watersnake comes factory-fitted with a standard length of twin flex
wiring with alligator clips to attach to the battery.
• Before connecting the motor’s cables to the battery terminals, ensure all
switches are in the OFF position and stand clear of the propeller.
• Connect the red cable to the positive (+) terminal and the black cable to the
negative (-) terminal, making sure the terminals are clean before doing so.
A clean connection will minimise power wastage and give you maximum
power from the battery.
• The voltage input must be 14.5V or lower. Voltage input above 14.5V will
damage the motor and void the warranty.
• If you intend to charge your battery via an alternator or solar panel, it is
important that the battery voltage output does not exceed 14.5v. If you are
unsure of the voltage your battery will output, consult a marine technician
or auto electrician.
CONNECTING YOUR MOTOR
TO THE BATTERY
Watersnake Asp Transom User Manual v3 2023-03-17.indd 10Watersnake Asp Transom User Manual v3 2023-03-17.indd 10 17/3/2023 4:36 pm17/3/2023 4:36 pm