www.watersnake.com.au
13
CAUTION: Please keep you fingers and hands away from all
hinge points and the propeller at all times.
(A)
(A)
(B)
(B)
DEPTH ADJUSTMENT
The depth of the motor in the water can be adjusted. Hold the motor shaft with
one hand, loosen the Depth Collar Adjustment Screw and set the motor to the
desired depth, then retighten the adjusting screw of the depth collar securely (A).
The motor should be just deep enough in the water so air does not get sucked
down to the propeller during operation (called ventilation). This reduces the
motor efficiency.
STEERING COUNTER-FORCE
The motor is steered by pivoting the Tiller Handle side-to-side. You can fine-tune
the steering counter-force so the motor will stay in the direction you are aiming
without the need for continual correction:
Adjust the amount of steering counter-force by loosening or tightening the
counter-force bolt so it is just tight enough to maintain the same direction (B).
Depth collar
height adjustment
Depth collar
height adjustment
Steering Counter-
Force adjustment
Steering counter
force adjustment
ASP T24 TILTING BRACKET
ASP T18 BRACKET
STOWING
When your
Watersnake
motor is not
in use always
stow and store
it properly.
Watersnake Asp Transom User Manual v3 2023-03-17.indd 13Watersnake Asp Transom User Manual v3 2023-03-17.indd 13 17/3/2023 4:36 pm17/3/2023 4:36 pm
To Next Page
Loading...
