www.watersnake.com.au
11
1. Place the Shear Pin in the hole of the Propeller Shaft as shown below.
2. Note on the inside of the Propeller there is a groove for the Shear Pin to
slot into. Place the Propeller over just the end of the Propeller Shaft, then
rotate the propeller to align the groove to the Shear Pin. Push the Prop
fully onto the Shaft, making sure the Pin sits in the groove.
3. While holding the Propeller, tighten the Propeller Nut firmly with the
provided tool.
ATTACHING THE PROPELLER
1
2
3
WARNING: Before doing anything with the propeller, ensure
the cables from the electric motor to the battery are disconnected.
Propeller Nut
Propeller
Tool to tighten the
Propeller Nut.
Propeller Shaft
Shear pin
Watersnake Asp Transom User Manual v3 2023-03-17.indd 11Watersnake Asp Transom User Manual v3 2023-03-17.indd 11 17/3/2023 4:36 pm17/3/2023 4:36 pm
To Next Page
Loading...
