Watlow Ez-Zone PM6 - Chapter 2: Install and Wire (Continued); Power Supply and Digital Input Wiring

Óç
Warning:
Use National Electric (NEC)
or other country-specific
standard wiring and safety
practices when wiring and
connecting this controller to
a power source and to elec-
trical sensors or peripheral
devices. Failure to do so may
result in damage to equip-
ment and property, and/or
injury or loss of life.
Note:
Maximum wire size termina-
tion and torque rating:
• 0.0507 to 3.30 mm
2
(30 to
12 AWG) single-wire termi-
nation or two 1.31 mm
2
(16
AWG)
• 0.8 Nm (7.0 lb.-in.) torque
Note:
Adjacent terminals may be
labeled differently, depend-
ing on the model number.
Note:
To prevent damage to the
controller, do not connect
wires to unused terminals.
Note:
Maintain electrical isolation
between analog input 1, digi-
tal input-outputs, switched
dc/open collector outputs and
process outputs to prevent
ground loops.
Note:
The control output common
terminal and the digital com-
mon terminal are referenced
to different voltages and
must remain isolated.
Watlow EZ-ZONE
®
PM PID Controller • 14 • Chapter 2 Install and Wire
Low Power
Power
power
power
98
99
CF
CD
CE
B5
D6
D5
Slot C
fuse
• Minimum/MaximumRatings
• 12to40VÎ (dc)
• 20to28VÅ (ac) Semi Sig F47
• 47to63Hz
• 14VAmaximumpowerconsumption(PM4,8&9)
• 10VAmaximumpowerconsumption(PM3&6)
PM_ _ [3,4] _ _ - _ _ _ _ _ _ _
High Power
Power
power
power
98
99
CF
CD
CE
B5
D6
D5
Slot C
fuse
• Minimum/MaximumRatings
• 85to264VÅ (ac)
• 100to240VÅ (ac) Semi Sig F47
• 47to63Hz
• 14VAmaximumpowerconsumption(PM4,8&9)
• 10VAmaximumpowerconsumption(PM3&6)
PM_ _ [1,2] _ _ - _ _ _ _ _ _ _
Digital Input 5, 6
input 5
common -
98
99
CF
CD
CE
B5
D6
D5
Slot C
input 6
Digital Input
• Updaterate10Hz
• Drycontactordcvoltage
DC Voltage
• Inputnottoexceed36Vat
3 mA
• Inputactivewhen>3V@
0.25 mA
• Inputinactivewhen<2V
Dry Contact
• Inputinactivewhen>
500 Ω
• Inputactivewhen<100Ω
• maximumshortcircuit13
mA
PM_ _ [2,4] _ _-_ _ _ _ _ _ _
Voltage Input
B
common
Vdc
D
_
_
Dry Contact
B
common
24 Vdc
_
_
D