Watlow EZ-ZONE
®
PM PID Controller • 68 • Chapter 8 Factory Page
Factory Page
Dis-
play
Parameter name
Description
Range Default
Parameter
Appears in
Menu When
Modbus
Relative Ad-
dress
CIP
Class
Instance
Attribute
hex (dec)
Profibus
Index
Data
Type
&
Read/
Write
[Cust]
[fcty]
Custom Menu
[`par]
[ Par]
Custom Menu
Parameter 1 to 20
Select the parame-
ters that will appear
in the Home Page.
The Parameter 1
value will appear in
the upper display of
the Home Page. It
cannot be changed
with the Up and
Down Keys in the
Home Page.
The Parameter 2
value will appear
in the lower display
in the Home Page.
It can be changed
with the Up and
Down Keys, if the
parameter is a
writable one.
Scroll through the
other Home Page
parameters with
the Advance Key
.
[nonE] None
[gSd1] Guaranteed Soak
Deviation 1 Value
[P;ACr] Profile Action
Request
[P;Str] Profile Start
[idLE] Idle Set Point
[t;tUn] TRU-TUNE+
®
Enable
[`r;rt] Ramp Rate
[`C;hy] Cool Hysteresis
[`C;Pb] Cool Proportional
Band
[`h;hy] Heat Hysteresis
[`h;Pb] Heat Proportion-
al Band
[``db] Dead Band
[``td] Time Derivative
[``ti] Time Integral
[`C;Pr] Cool Power
[`h;Pr] Heat Power
[`C;M] User Control
Mode
[`AUt] Autotune
[``op] Open Loop Set
Point
[AC;SP] Active Set Point
[AC;pu] Active Process
Value
[StPt] Set Point
CUSt] Custom Menu
[`A;hy] Alarm Hysteresis
[`A;hi] Alarm High Set
Point
[`A;Lo] Alarm Low Set
Point
[USr;r] User Restore Set
[`C_F] Display Units
[`i;CA] Input Calibration
Offset
[`Pro] Process
See:
Home
Page
Always - - - - - - - - - - - - - - - -
[`iid]
[ iid]
Custom Setup (1 to
20)
Instance ID
Select which instance
of the parameter will
be selected.
1 to 4 If there
is only
one valid
instance
for cor-
respond-
ing class
member
then not
active,
otherwise
active.
- - - - - - - - - - - - - - - -
Note:
Some values will be rounded off to fit in the four-character display. Full values can be read with
other interfaces.
If there is only one instance of a menu, no submenus will appear.
R: Read
W: Write
E:
EEPROM
S:
User
Set
To Next Page
Loading...
