3.1.3 Confirm Ethernet DHCP Configuration
Once you have confirmed that the Ethernet connection is working, complete the following steps
to confirm that the connection is active.
1. Connect your computer to the network jack that will be used by the Controller. Your computer
should be configured to automatically get a network address. Boot or reboot your computer.
2. Open a web browser and go to www.google.com.
3. Confirm that you can access the Google home page without entering a password, which
confirms that the connection is active, provides DHCP addresses, and allows access without
a password.
NOTE:
Static addresses are not required or recommended by AERCO. Reserved addresses are a
simpler solution.
To Next Page
Loading...
Need help?
General
