SmartPlate Installation, Operation & Maintenance Manual
APPENDIX A – MODBUS CONTROL AND COMMUNICATION
OMM-0069_0H • SP-100 • 1/30/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 96 of 134
A.1 TEMPERATURE CONTROLLER (EUROTHERM 2408) PROCEDURES
The following sections provide the procedures to add a Modbus Communication board to the
Temperature Controller and change communication addresses.
A.1.1 Adding a Communication Board to the Temperature Controller
Parts Needed:
a. ECS/SP Control Box Assembly, P/N: 69096-TAB]
b. Temperature Indicating Controller, P/N: 64008
c. Communications Board, P/N: 64009-TAB
ADDING A COMMUNICATION BOARD Instructions
1. Turn off power to ECS/SP Control Box Assembly
2. Slide out Temperature Indicating Controller (P/N: 64008) from Control Box Assembly by
gently pushing the indicated latching ears to the side (See Figure A-1).
Figure A-1
3. Slide Communications Board (P/N 64009-TAB) into Temperature Indicating Controller slot
(COMMS 1). See Figure 2. Make sure to push Communications Board all the way in to
ensure it is firmly seated in its slot.
Figure A-2
To Next Page
Loading...
