CLEANING THE SPA
Detergent residues, dissolved solids from swimwear and chemicals will gradually accumulate in the spa’s water. To clean the spa,
use soap and water then rinse.
NOTE: do not use hard brushes or abrasive cleaners.
REPAIRING YOUR WAVE SPA: Wave spa provides you with a repair patch for incase the spa is torn or punctured. To use the
repair patch; dry the damaged area and use the glue provided to attach it to the damaged area. Be sure to smooth the surface to
remove any air bubbles.
TROUBLE SHOOTING
Please use these helpful tips to help you to diagnose and rectify some common sources of trouble.
WATER PROTECTION LEVEL: Water protection levels differ depending on the zone. For full information, please refer to the below
scheme:
Jet system does
not operate
- Air pump is too hot
- Error with the power box
- Unplug the air pump. After the air pump has cooled, insert the
plug and press the Jet button to activate
- Call for service if it does not reset
Heating system
does not operate
- Temperature set too low
- Dirty filter cartridge
- Improper water levels
- Heating element failed
- Set to a higher temperature (20-42°C)
- Clean/replace the filter cartridge in time
- Add water to specified levels
- Call for service
Filtering
system does not
operate
- Dirty filter cartridge
- Something is wrong with the
power box
- Voltage too low
- Incorrect voltage frequency
- Clean/replace the filter cartridge in time.
- Call for service if it does not reset.
- Seek expertise from an electrician to check whether the
household input voltage or frequency is normal
To Next Page
Loading...
