Wave ATLANTIC - Trouble Shooting; Drainage and Storage; Repair Kit Usage; Common Problems and Solutions

The indicator lamp for the heating system will still be on but the heating will not work. Stop this by pressing the FILTER KEY once. The letters ‘FC’ on the
display screen and the warning tone will then disappear. Actual water temperature will reappear on the display screen and all keys will return to normal
working status.
BUBBLE KEY – This is an ON/OFF key for the jet system. Press this key to activate the air pump. Press again to turn the jet system
off. The red indicator light should be ON whenever the bubble key light should be ON whenever the pump is active. This system will automatically stop after
20 minutes. If you require more air, you must wait for 10 minutes and then press the BUBBLE button again. During the first 15 minutes of the bubble key
being activated, bubbling can be stopped and re-started. IF the bubble key has been active for more than 15 minutes, this function can be stopped but not
re-started for another 10 minutes.
HEATER KEY – This is an ON/OFF key for the heating system. Press this key to activate the heater. Press again to turn the heater
off. The red indicator light should be ON whenever the heater is active. Whenever the heater is on, the filter pump will also start working and therefore the
filter pump light should be on too. Once the preset temperature has been reached, the heater will stop working. However, the light will remain ON, the
filter will remain active and the filter key light will remain ON. When the temperature drops to 2 below the preset temperature, the heating system will re-
activate.
TEMPERATURE ADJUSTMENT KEY – Press the ‘UP’ arrow to increase the temperature and the ‘DOWN’ arrow to
decrease the temperature. Pressing the Temperature Increase or Decrease buttons will cause the LED to flash. When it is
flashing you can adjust to the desired temperature setting. The new and desired temperature setting will remain on the LED
display for 3 seconds to confirm the new value.
LED SCREEN - Once powered-up the LED displays the current water temperature automatically.