Body of spa
INFLATION: the wave spa’s air pressure for the inflation of the water tank is indicated by the green area of the pressure gauge.
If the gauge does not reach the green area, air inflation can continue until the gauge reaches the green area. If the air pressure
goes beyond the green area, stop the air inflation immediately.
FILLING YOUR WAVE SPA: water should be filled to a position 20mm higher than the water line. If the water is filled too low,
then the heating system may not work properly. If the spa is filled too high, water may spill over the tank when in use.
STORING YOUR WAVE SPA: To avoid damage due to cold weather, during winter months and cold weather conditions the
spa should be kept deflated and indoors. Drain off the water from inside the spa and ensure it is completely dry. Lay the spa
aside for 24 hours to exhaust the air. Once the air has been exhausted, fold carefully and place inside the woven bag provided.
The spa must be stored in a shaded place to avoid damage from direct sunlight.
To Next Page
Loading...
