SETTING THE TEMPERATURE
To set the temperature, press the ‘HEATER’ button and the numbers on the display screen will
start to flash. You can increase and decrease the temperature by pressing the UP/DOWN
buttons. When you have chosen your desired temperature, press the ‘HEATER’ button again to
confirm. Temperatures can be set between the range of 20°C / 68°F to 40°C / 104°F. (See
safety instructions for recommended operating temperatures).
FREEZE PROTECT
To activate Freeze Protect, adjust the heater temperature down to 20°C / 68°F then click
DOWN button once more until the controller display shows FP. This will then regulate the
water temperature so that if it falls below 5°C (41°F) the heater will automatically come on to
avoid water freezing inside the system.
UP
DOWN
®
OPERATING YOUR WAVE SPA
FILTRATION SYSTEM
To use the filtration system, press the ‘FILTER’ button, a light will appear and the pump will
start to work. Press the ‘FILTER’ button again once to stop the pump, the light will go out.
As a reminder to change your filter, after approx. 168 hours, the letters ‘FC’ will appear on the
display screen, accompanied by a warning tone. The light will still be lit on the ‘FILTER’ button,
but the pump will not be operational. The heating system will also not work and the light will
also be out on the ‘HEATER’ button. To make sure the filtration system is off, press the
‘FILTER’ button again. The letters ‘FC’ on the display screen will disappear as well as the
warning tone. The water temperature will be displayed, and functions will return to their
normal status. Please refer to Page 15.
HEATER
To start the heating system, press the ‘HEATER’ button, a light will appear. Press the ‘HEATER’
button again once and the heating system will stop and the light will go out. When you turn the
heating system on, the filter system will switch on to circulate water automatically. When the
temperature reaches the pre-set temperature the heating system will stop, but the heating
indicator light will remain lit. The filter pump will continue to operate even when the heater is
not functioning. When the water falls below the pre-set temperature, the system will begin to
automatically heat the water again.
HEATER
FILTER
Warning! Do not operate the pump and heater system whilst the spa is empty,
as this may damage the system.
To Next Page
