Mount
Fastening system
Power density
indicator from 10%
to 200% of limit (LED)
USB connector
Tripod socket
Opening for securing
ON/OFF button and
status indicator
4. FIRST STEPS
The WaveMon RF is an easy-to-use and very complete electromagnetic eld
monitor. To switch it on, press the ON/OFF button on the front panel. The
device will switch on and go through the start-up sequence to check that all the
warning systems are working properly and that the batteries are suitable to run
the device.
The sequence is:
• 2 beeps vibration for 1 second all the white LEDs light up the
battery status is displayed with the blue LEDs for a few seconds.
Figure 2: Parts of the WaveMon
User’s Manual Personal equipment WaveMon P. 6
To Next Page
Loading...
Need help?
General