Fifth section: System information:
You can check the device’s serial number,
rmware version, etc. You can also click on
'Copy information to clipboard' to save all the
system information and send it to your support
contact if necessary.
9.4 Registration
When the software is run and the WaveMon RF is connected for the rst time,
a pop-up window will appear allowing you to register with the Wavecontrol’s
Intranet. We strongly recommend registering, since it will allow you access
to support documents and you will need it for obtaining free software and
rmware updates (see section 11 on updates and Appendix 1 on the intranet).
10. BATTERIES
10.1 Use
The WaveMon RF uses 2 rechargeable AA Ni-Mh batteries. Any type of Ni-Mh
battery can be used as long as the 2 batteries are the same model.
When the unit is switched on, the unit displays the battery status with blue
lights for a few seconds. This status can be: full battery with all LEDs on,
medium battery with 4 LEDs on, low battery with 2 LEDs on.
Once it has been switched on, the device indicates the battery charge level:
blinking white means the batteries are sufcently charged; blinking red means
the batteries are in very low level.
If you do not have enough time to recharge the batteries or if they are defective,
they can easily be replaced by removing the two screws at the bottom of the
device. You will need a cross-head screwdriver for this.
User’s Manual Personal equipment WaveMon P. 17
To Next Page
Loading...
Need help?
General