Waveshare RS485 TO ETH User Manual

485 TO ETH (B) User Manual
27 / 36 www.waveshare.com
If you receive {alert:"on"} JSON data, you need to use the 05 command to set the
station address 02 and the coil starting with register 03. Then in: JSON to Modbus interface,
click "JSON Delivery"
Figure 28 Enter JSON to send
The configuration interface is as follows: pay attention to the alert: "on setting that
needs to be written.
Figure 29 Configure coil

Waveshare RS485 TO ETH Specifications

General

Interface	RS485 to Ethernet
Ethernet Port	10/100Mbps
RS485 Port	1 port
Baud Rate	300bps ~ 115200bps
Communication Interface	Ethernet, RS485
Protection	Surge protection
Operating Temperature	-40°C to 85°C
Communication Protocol	TCP/IP, UDP
Storage Temperature	-40℃ ~ 85℃
Humidity	5% ~ 95%
Function	RS485 to Ethernet converter