Waveshare WS-431E - Page 24

WS-431E 4G Router
www.waveshare.com
24
/
68
www.waveshare.com/wiki
The static route has the following parameters. By default, a maximum of 20 static routes can be
added.
Name
Description
Default parameter
port
Lan, wan_4G, wan_wired, vpn
interfaces
Lan
Object (destination
address)
The address or address range of the
object to be accessed
empty
Subnet mask
The subnet mask of the object network
to be accessed
empty
Gateway (Next hop)
The address to forward to
empty
Metric
Number of packet hops
empty
Figure 27 Static route parameter table
Static route describes the routing rules of Ethernet packets.Test example: Test environment, two
flat routers A and B, as shown below.
Figure 28 Static routing table example diagram
The WAN ports of routers A and B are connected to the network at 192.168.0.0. The LAN port of
router A is on the 192.168.2.0 subnet, and the LAN of router B is on the 192.168.1.0 subnet.Now,
if we want to make A route on router A so that when we access the 192.168.1.x address, it is
automatically forwarded to the router