Wavetek 9100 - Page 78

18-4 Model 9100 — Operator's Guide: Error Messages
Error Messages
18
18.3 Alphabetic List of Error Messages
Error Message Error
Type
A
Amplitude outside limits D
A valid Cold Junction temperature is required D
B
Bottom of range B
C
Cal is password protected D
Cal switch not enabled D
Cannot change: delta Φ still selected B
Cannot change: Φ ref out still selected B
Cap meas no 1st reading
The first of the two measurements required
for capacitance calibration is missing
D
Cap meas no 2nd reading
The second of the two measurements required
for capacitance calibration is missing
D
Cap meas outside limits D
Century entry is not a valid number
The first two digits of the year entered are
not 19 or 20
F
Changing current setting gives best UUT performance
UUT sense current high. Internal circuits saturated. B
Cold junction measurement invalid. Default = 25°CE
Confirm with ON B
Corrupt +ve zero (DAC) D
Corrupt -ve zero (DAC) D
Corrupt cal factors D
Corrupt cold junc diff factor E
Corrupt composite DAC zero D
www.valuetronics.com