Model 9100 — Operator's Guide: Error Messages 18-5
Error Messages
18
Error Message Error
Type
Corrupt factors:- substitution
A nominal correction factor has been substituted for
invalid data in the non-volatile memory
D
Corrupt LFAC correction
The low frequency AC correction factor is corrupted
D
Corrupt lookup table
The required value in the DAC characterization
look-up table is corrupted
D
Corrupt main DAC gain D
Corrupt offset DAC factor D
Corrupt polarity gain (DAC) D
Corrupt res. ref. factor D
Corrupt selfcal factor D
Corrupt trim DAC gain D
Corrupt Vmax. Vmin D
D
DAC Default Charactn. Failed
An attempt to load the DAC characterization
look-up table with default values has failed
A
Day entry is not a valid day F
Day entry is not a valid number F
Day separator is incorrect F
Deviation too big B
Deviation too small B
Down range required B
Duty too big B
Duty too small B
E
Entry contains illegal characters B
Entry does not give a valid time setting F
www.valuetronics.com
To Next Page
Loading...
