5
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Tools Required
SAFETY GLASSES
PLIERS/CUTTERS
1/2, 7/16” & 9/16”
WRENCHES
5/8”, 1/2”, 7/16”
& 9/16” SOCKET
PHILLIPS HEAD
SCREWDRIVER
RATCHET WRENCH
POWER DRILL
SAWHORSE
GLOVES
1/2”, 7/16” SOCKET
DRIVER
HAMMER
VICE GRIPS
STEP LADDER
TAPE MEASURE
LEVEL
VICE CLAMPS
PENCIL
3/16”, 7/16” & 1/8”
DRILL BITS
FLAT TIP SCREWDRIVER
3” EXTENSION
Counterbalance spring tension must always be released before any attempt is made to start removing an existing door.
A POWERFUL SPRING RELEASING ITS ENERGY SUDDENLY CAN CAUSE SEVERE OR FATAL INJURY. TO AVOID
INJURY, HAVE A TRAINED DOOR SYSTEMS TECHNICIAN, USING PROPER TOOLS AND INSTRUCTIONS, RELEASE
THE SPRING TENSION.
For detailed information see supplemental instructions “removing an existing door/preparing the opening”. These instructions are
available at no charge from Wayne-Dalton Corp., P.O. Box 67, Mt. Hope, OH 44660, or at www.wayne-dalton.com.
HACKSAW
Removing An Existing Door
WARNING
To Next Page
Loading...
Need help?
General
