Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
13
TO AVOID POSSIBLE INJURY OR
PROPERTY DAMAGE, KEEP PEOPLE AND
OBJECTS CLEAR OF THE MOVING DOOR
ARM.
NOTE: If necessary, activate the opener
to move the trolley/ upper door arm to the
closed position.
NOTE: If you have a 9100, 9400,9600,
5120, 5140 or 9700 series door, with one of
the door brackets shown at the right and a
Torquemaster
®
or Extension Spring(s)
counterbalance system, see “Setting Trolley
Close Position/ Connecting Door Arm To
Door” on pages 23-24. If not, complete this
step.
NOTE: If you have a 9100, 9400, 9600,
5120, 5140 or 9700 series door, with one of
the door brackets shown at the right and a
Torsion Spring(s), see “Setting Trolley Close
Position/ Connecting Door Arm To Door” on
pages 25-26. If not, complete this step.
Trolley and latch assembly must be at the
factory preset fully closed position, (see
illustration).
Verify preliminary trolley and latch assembly
close position is 11” to 13” between trolley
clevis pin and the inside face of the door.
If adjustment of the trolley/latch assembly
position is required, use the close travel
adjustment screw located on the bottom of
the opener. A 1/4 turn equals approximately
1” of trolley travel; turn clockwise to de-
crease distance between header and trolley
and counter-clockwise to increase distance
between header and trolley.
OPEN
CLOSE
MORE
LESS
MORE
TRAVEL ADJUSTMENT
Setting Trolley Close Position
17
Tools Needed:
Pliers/Wire Cutters
Tape Measure
Flat Tip
Screwdriver
Bottom Of Opener
Door Bracket
Upper Arm
Trolley
(Closed Limit Position)
11” to 13”
(13” Minimum
For Belt Drive)
Pull Knob
Release Cord
Tag
WARNING
Models: 9100, 9400, 9600, 5120 and 5140.
Single and Double Tab Door Brackets
Model: 9700
Single Tab
Bracket
Double Tab
Bracket
Single Tab
Bracket
Double Tab
Bracket
To Next Page
Loading...
Need help?
General
