DBW 2010 / 2016 Initial start-up
51
11 Initial start-up
NOTE:
Refer to the safety instructions in the operating and maintenance
instructions.
The operating and maintenance instructions must be read through
without fail before starting the heater.
After you have installed the heater, bleed the water system and the fuel
supply system carefully. Follow the instructions supplied by the vehicle
manufacturer for this purpose.
Conduct a trial of the heater to check all the water and fuel connections
for leaks and to ensure that they are secure. If the heater suffers a fault
during operation, the fault must be located and remedied.
1303560C_DBW 2010 EA_degbfr.book Page 51 Tuesday, March 5, 2013 9:05 AM
To Next Page
