DVS 400 Fast Charging System Operation and Maintenance Manual
09190-W-03-01 Page 7 of 27 Webasto Charging Systems, Inc.
1. Ensure the DVS 400 Fast Charging System installation and utility power requirements are followed. (Refer to
DVS 400 Installation Manual).
2. Install the Battery Monitor / Identifier (BMID) onto the battery pack. (Refer to BMID or BatteryRx Installation
Manual)
3. Once BMID is installed, the battery pack may be connected to the charger.
4. If your BMID does not come pre-configured, you will need to initialize the new BMID. (Refer to BMID
Programming and Advanced Features Manual)
5. Once the BMID has been initialized, the battery pack is ready to begin charging.
1.2 Applicable Documents
DVS 400 Installation Manual
BMID Programming and Advanced Features
BatteryRx Installation Manual
16672-W-03
To Next Page
Loading...
Need help?
General
