21
Step 20
Complete accessory installation
You will need: Warm-Up Basket, warming rack, work
table, accessory rack, three tubing plugs, thermometer
and a hammer.
Insert one end of the Weber Warm-Up Basket into the hole
in the right end of the lid and the other end into the slot in
the left end of the lid. Figure 26 (a).
Set the warming rack into the slots at the rear of the
cooking box. Figure 26 (b).
Set the work table onto the left side rails. Figure 26 (c).
Set the accessory rack in place between the two frame
connectors. Figure 26 (d).
Insert the thermometer into its holder. Figure 26 (e).
Insert the tubing plugs into the ends of the frame. To fully
seat the plugs, you may have to tap them lightly with a
hammer. Figure 26 (f).
Figure 26
(a)
(b)
(c)
(d)
(e)
(f)
CAUTION: To keep the barbecue stationary, the tabs
on the locking casters should be in the down position.
To Next Page
Loading...
Need help?
General
