EasyManuals Logo

Weber genesis II E-310 GBS User Manual

Weber genesis II E-310 GBS
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
Getting Started
UNLOCK GRILLING HAPPINESS
LPG Cylinder Installation
&LeakChecking
Connect the Regulator to the Cylinder
1) Check that all burner control knobs are in the
o position. Check by pushing in and turning
knobs clockwise.
2) Identify your regulator type and connect the
regulator to the LPG cylinder by following the
appropriate connection instructions.
Note: Confirm that the LPG cylinder valve or regulator
lever are closed before connecting.
Connect by Turning Clockwise (A)
Screw regulator onto cylinder by turning fitting
clockwise (a). Position the regulator so that the vent
hole (b) faces down.
Connect by Turning Anti-Clockwise (B)
Screw regulator onto cylinder by turning fitting
anti-clockwise.
Connect by Turning Lever and
Snapping into Position (C)
Turn regulator lever (a) clockwise to the o position.
Push regulator down on cylinder valve until
regulator snaps into position (b).
Connect by Sliding Collar (D)
Make sure regulator lever is in the o position (a).
Slide the collar of the regulator up (b). Push the
regulator down onto the cylinder valve and maintain
pressure. Slide collar down to close (c). If regulator
does not lock, repeat procedure.
Note: The regulator illustrations shown in this manual
may not be similar to the regulator you are using for your
grill, due to dierent country or regional regulations.
Placement of the LPGCylinder
The size and shape of the cylinder determine if the
cylinder is placed on the cylinder hanger or placed on
the ground.
1) Identify your LPG cylinder type and follow the
appropriate placement instructions.
Hanger Placement (E)
Turn the cylinder so the valve opening faces the
front of the grill. Lift and place the cylinder on
the hanger. Adjust the belt so that it is tight to the
cylinder.
Ground Placement (F)
Place the cylinder on the ground outside the base
cabinet on the right side of the grill. Turn the
cylinder so the valve opening faces the front of
thegrill.
68096_00000_Gen_II_LP_030117_EN.indd 10 2/20/17 12:57 PM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Weber genesis II E-310 GBS and is the answer not in the manual?

Weber genesis II E-310 GBS Specifications

General IconGeneral
TypeGrill
Heat source-
Total power10990 W
Electronic ignitionYes
Adjustable thermostatNo
Number of cooking zones3 zone(s)
Form factorCart
Product colorBlack
Cooking surface shapeRectangular
Cooking surface (W x D)680 x 480 mm
Control typeRotary
Number of wheels2 wheel(s)
Weight and Dimensions IconWeight and Dimensions
Depth1143 mm
Width1371.6 mm
Height736.6 mm
Weight60600 g

Related product manuals