11
Getting Started
m DANGER: Do not use a flame to check for gas
leaks. Besure there are no sparks or open
flames in the area while you check for leaks.
m DANGER: Leaking gas may cause a fire or
explosion.
m DANGER: Do not operate the grill if there is a
gas leak present.
m DANGER: If you see, smell, or hear the hiss of
gas escaping from the LPG cylinder:
1. Move away from LPG cylinder.
2. Do not attempt to correct the problem
yourself.
3. Call the emergency fire services.
m DANGER: Always close the cylinder valve
before disconnecting the regulator. Do not
attempt to disconnect the gas regulator and
hose assembly or any gas fitting while this
grill is in operation.
m DANGER: Do not store a spare LPG cylinder
under or near this grill. Never fill the cylinder
beyond 80% full. Failure to follow these
statements exactly may result in a fire causing
death or serious injury.
What is a Leak Check?
Once the LPG cylinder is properly installed, it is
necessary to perform a leak check. A leak check is a
reliable way to verify that gas is not escaping after you
connect the cylinder. The fitting where the regulator
connects to the cylinder should be tested each time a
cylinder is refilled andreinstalled.
Checking for Gas Leaks
1) Wet fittings at cylinder and regulator with a soap
and water solution, using a spray bottle, brush
or rag. You can make your own soap and water
solution by mixing 20% liquid soap with 80% water;
or, you can purchase leak check solution in the
plumbing section of any hardware store.
2) Identify your regulator type. Turn gas supply on
by turning cylinder valve anti-clockwise (G) or by
moving regulator lever to the on position(H).
3) If bubbles appear (I) at the regulator-to-cylinder
connection or the regulator hose-to-regulator
connection, there is a leak:
a) Turn gas supply o. DO NOT OPERATE
THE GRILL. Contact the Customer Service
Representative in your area using the contact
information on our website.
4) If bubbles do not appear, leak checking is complete:
a) Turn gas supply o and rinse connections
withwater.
NOTE: Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should
be rinsed with water after checking for leaks.
Additional Leak Check Precautions
The fuel system in your grill features other
connections and fittings. These factory-made
connections have been thoroughly checked for gas
leaks and the burners have been flame-tested.
Weber recommends performing an additional
thorough leak check after assembly, as well as
annually. Instructions for this can be found online at
weber.com.
Disconnect the Regulator from
theCylinder
1) Confirm that the LPG cylinder valve or regulator
lever are fully closed.
2) Disconnect the regulator.
BARBECUE
MITTS
When it doubt, wear them. The good
ones are insulated and protect
both hand and forearm.
M
U
S
T
-
H
A
V
E
G
R
I
L
L
I
N
G
T
O
O
L
S
•
M
U
S
T
-
H
A
V
E
G
R
I
L
L
I
N
G
T
O
O
L
S
•
M
U
S
T
-
H
A
V
E
G
R
I
L
L
I
N
G
T
O
O
L
S
•
M
U
S
T
-
H
A
V
E
G
R
I
L
L
I
N
G
T
O
O
L
S
•
M
U
S
T
-
H
A
V
E
G
R
I
L
L
I
N
G
T
O
O
L
S
•
FOILPANS
Perfect for lining the
catchpan to make cleanup
convenient and easy.
M
U
S
T
-
H
A
V
E
G
R
I
L
L
I
N
G
T
O
O
L
S
•
M
U
S
T
-
H
A
V
E
G
R
I
L
L
I
N
G
T
O
O
L
S
•
M
U
S
T
-
H
A
V
E
G
R
I
L
L
I
N
G
T
O
O
L
S
•
M
U
S
T
-
H
A
V
E
G
R
I
L
L
I
N
G
T
O
O
L
S
•
M
U
S
T
-
H
A
V
E
G
R
I
L
L
I
N
G
T
O
O
L
S
•
68096_00000_Gen_II_LP_030117_EN.indd 11 2/20/17 12:58 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
