10
Getting Started
What is a Leak Check?
Once the LPG cylinder is properly installed, it is
necessary to perform a leak check. A leak check is a
reliable way to verify that gas is not escaping after you
connect the cylinder. The following fittings should be
tested each time a cylinder is refilled and reinstalled:
• Where the regulator connects to the cylinder.
• Where the gas hose connects to the bulkhead.
• Where the bulkhead connects to the corrugated gas
line.
Checking for Gas Leaks
1) Wet fittings with a soap and water solution, using a
spray bottle, brush or rag. You can make your own
soap and water solution by mixing 20% liquid soap
with 80% water; or, you can purchase leak check
solution in the plumbing section of any hardware
store.
2) Identify your regulator type. Turn gas supply on
by turning cylinder valve anti-clockwise (F) or by
moving regulator lever to the on position(G).
m DANGER: Do not use a flame to check for gas
leaks. Besure there are no sparks or open
flames in the area while you check for leaks.
m DANGER: Leaking gas may cause a fire or
explosion.
m DANGER: Do not operate the barbecue if there
is a gas leak present.
m DANGER: If you see, smell, or hear the hiss of
gas escaping from the LPG cylinder:
1. Move away from LPG cylinder.
2. Do not attempt to correct the problem
yourself.
3. Call the emergency fire services.
m DANGER: Always close the cylinder valve
before disconnecting the regulator. Do not
attempt to disconnect the gas regulator and
hose assembly or any gas fitting while this
barbecue is in operation.
m DANGER: Do not store a spare LPG cylinder
under or near this barbecue. Never fill the
cylinder beyond 80% full. Failure to follow
these statements exactly may result in a fire
causing death or serious injury.
To Next Page
Loading...
Need help?
General
