Attaching the holder using self-tapping screws
You can use two self-tapping screws to fix the holder to your vehicle.
Note: Please refer to the list of what's in the box, to check that the self-tapping screws (3.5 x 16 mm, 1/7
x 5/8 inches) are included in your product package.
1. Choose a flat surface for the LINK 640.
Remember, when the LINK 640 is in the holder, it must not be obstructed by metal objects.
2. Insert the screws into the corresponding holes in the holder.
3. Tighten the screws.
4. Carefully place the LINK 640 in the holder until it clicks into place.
14
To Next Page
Loading...
