Resetting the LINK 640
If your LINK 640 does not operate properly or signals a system error you may need to restart or reset the
unit. Only restart or reset the LINK 640 after you have made sure you have carried out all previously de-
scribed steps without success.
Restarting your LINK 640
To restart your LINK 640, press the reset button with a thin pointed object until it clicks and keep it pressed
down for 1 to 2 seconds. The LINK 640 restarts within approximately five seconds after releasing the but-
ton.
If restarting the device does not succeed remove the Power/CAN cable from the LINK 640. Then plug it into
the Power/CAN cable connector again.
Resetting your LINK 640 to factory settings
To reset the LINK 640 to factory settings, press the reset button with a thin pointed object until it clicks and
keep it pressed until the green LED starts flashing rapidly. The LINK 640 reboots within approximately five
seconds after releasing the reset button.
Important: All information stored on the LINK 640 is deleted during a factory reset.
19
To Next Page
Loading...
