EasyManua.ls Logo

Webfleet PRO 2020 - Triman logo; Technical Specifications; FCC information for the user

Default Icon
35 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The owner of the WEBFLEET contract decides what purposes this information is subsequently
used for, who will have access to it, and for how long the information is kept. Please refer to the
owner of the WEBFLEET contract for any additional information. This will usually be the owner
or lessee of the vehicle.
Triman logo
Technical Specifications
Supply voltage
12 V / 24 V (minimum 9 V to maximum 30 V)
Maximum power consumption
At 14 V: 0.03 A
At 28 V: 0.05 A
Frequencies
Wireless interface: 13.56 MHz
FCC information for the user
THE DEVICE COMPLIES WITH PART 15 OF THE FCC RULES
Federal Communications Commission (FCC) Statement
This equipment radiates radio frequency energy and if not used properly - that is, in strict
accordance with the instructions in this manual - may cause interference to radio
communications and television reception.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
This device has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
29

Table of Contents

Related product manuals