Important
This equipment was tested for FCC compliance under conditions that included the use of
shielded cables and connectors between it and the peripherals. It is important that you use
shielded cable and connectors to reduce the possibility of causing radio and television
interference. Shielded cables, suitable for the product range, can be obtained from an
authorized dealer. If the user modifies the equipment or its peripherals in any way, and these
modifications are not approved by Webfleet Solutions, the FCC may withdraw the user’s right
to operate the equipment. For customers in the USA, the following booklet prepared by the
Federal Communications Commission may be of help: "How to Identify and Resolve Radio-TV
Interference Problems". This booklet is available from the US Government Printing Office,
Washington, DC 20402. Stock No 004-000-00345-4.
FCC ID: 2AGPAPRO202
IC: 20911-PRO202
This device complies with Industry Canada’s licence-exempt RSSs.
FCC RF Radiation Exposure Statement
The transmitters within this device must not be co-located or operating in conjunction with any
other antenna or transmitter.
FCC Country Code Selection
The Country Code Selection feature is disabled for products marketed in the US or Canada. Per
FCC regulations, all Wi-Fi products marketed in US must be fixed to US operation channels
only.
Location of FCC ID and IC ID information on your device
The FCC ID and IC ID can be found on the label attached to the bottom side of your device.
Responsible party in North America
TT Telematics USA Inc., 100 Summit Drive, Burlington, MA
Responsible party in Chile
Webfleet Solutions Chile SpA , Apoquindo 3910, Piso 8, Edificio Las Torcazas, Las Condes,
7550029 Santiago, Chile
Customer support contact
US: 1-866-459-3499
Chile: (+56) 2 2584 7172
Emissions information for Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
▪
This device may not cause interference.
▪
This device must accept any interference, including interference that may cause undesired
operation of the device.
Operation is subject to the condition that this device does not cause harmful interference.
This Class B digital apparatus complies with Canadian ICES-003. CAN ICES-3(B)/NMB-3(B)
The Country Code Selection feature is disabled for products marketed in the US or Canada.
Equipment is certified to the requirements of RSS-210 for 13.56 MHz.
IMPORTANT NOTE
IC Radiation Exposure Statement:
▪
This equipment complies with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment.
30
To Next Page
Loading...
