◎Wiring must be completed by qualified professional electricians, otherwise, there may be
electric shock or damage to the AC Drive.
◎The power must be disconnected during wiring; otherwise, it may cause electric shock or fire.
◎The grounding terminal should be effectively grounded; otherwise, the outer casing of the AC
Drive may be energized.
◎Do not touch the main circuit terminals, otherwise, it may cause electric shock.
◎Terminals for brake resistor are (+) and PB. Do not wire to other terminals, otherwise, fire may
be caused.
◎It is only allowed to power on the AC Drive after the wiring is finished and its cover is reinstalled.
It is strictly prohibited to remove the cover of AC Drive while power is on. Otherwise, it may cause
electric shock.
◎Before programming the AC Drive with fault auto reset or restart option after power off, the
mechanical device need to be implemented with safety protection measures first. Otherwise,
personal injury will be caused.
◎“ STOP/RESET” key may become invalid as a result of some function setting. It is recommended
to install an independent emergency circuit breaker for the AC Drive control system, otherwise,
or personal injury may be caused.
◎When the power is on, there may be electricity in the AC Drive’s terminals even if it is in stop
mode. Do not touch U, V, W terminals and motor connection terminals, or electrical shock may be
caused.
◎Never touch the AC Drive connection terminals when power is on. Otherwise, it may cause an
electrical shock.
◎Only qualified electricians can be authorized to do the jobs of maintenance, checking, or parts
replacement.
◎After the power supply is OFF, make sure the charge LED is OFF and the residual voltage does
not exist, or wait for at least 10 minutes before carrying out maintenance or inspection.
Otherwise, damage or injury may be caused.
◎Modification to the AC Drive without permission is strictly prohibited, otherwise, severe injury
may be caused. Arbitrarily modification of AC Drive will result in service warranty invalid.
To Next Page
Loading...