Weider 130 Bench - Assembly Step 7: Pad Tubes and Foam Pads; Assembly Step 8: Final Tightening Check

9
8. Make sure that all parts are properly tight-
ened before you use the weight bench.
7. Attach an M8 x 15mmBolt (29) and an M8
Nylon Locknut (27) to the last hole in the Pivot
B
racket (6).
I
nsert the two Pad Tubes (10) into the Front
Leg (2). Slide the four Foam Pads (9) onto the
Pad Tubes.
7
9
2
9
9
27
29
6
10