Weider 6900 - Seat Assembly

19
31. Thread an M12 Nut (84) all the way onto the
High Cable (55).
Place a Large Washer (85) on top of the Weight
Selector (24).
Tighten the High Cable (55) into the Weight
Selector (24) until all the slack is removed from
the cables.
Tighten the M12 Nut (84) against the Large
Washer (85).
Tip: If the High Cable (55) does not reach
to the Weight Selector (24), see step 25. If
more than two threads of the Low Cable (53)
are showing above the M6 Locknut (51), adjust
the Locknut so that only two threads of the Low
Cable are showing.
55
84
85
24
32. Attach the Backrest (16) to the Backrest Frame
(61) with two M6 x 16mm Screws (62), an
M6 x 35mm Screw (64), and an M6 Washer (82).
Insert the Backrest Frame (61) into the Upright
(3) and tighten a Short Knob (33) into the Upright
and one of the holes in the Backrest Frame.
33. Orient the Seat (15) so that the wide end (E) is in
the indicated location.
Attach the Seat (15) to the Seat Frame (73) with
four M6 x 16mm Screws (62).
Insert the Seat Frame (73) into the Seat Tube (6)
and tighten a Short Knob (33) into the Seat Tube
and one of the holes in the Seat Frame.
32
33
16
64
61
62
82
3
E
Seat Assembly
33
31
15
73
33
62
6
62